
問題1:
一般socket 40mm 太高不能放進一级頭 Problem
1: Normal socket 40mm is too high need to be shorten to fit into
yoke nut. |

Yoke 頭只有26mm高那麽一般socket 不適用
Yoke has a clearance of 29mm so the socket
cannot be taller than this limit. |

問題2:
一般socket連接推桿是1/4" 接口,接口太大不能通過yoke
螺絲 Problem 2: Normal drive extension has
1/4" connection, this is too big for pass through yoke
screw
|
接口太大不能通過
too big for pass through |

先把socket上段及下段切去
first remove the upper and lower parts of socket |
|

把socket周邊打磨至圓滑 socket
edge has to be curve for fitting |

原先socket 是1/4"要改為3/8"
Socket come with 1/4" connection need to be
an extra fitting to become 3/8" |

用一個14mm 3/8"socket 磨平四面至1/4"
use a 14mm 3/8" socket, cut 4 sides to
become 1/4"
|

把長度缩短 cut
socket to approate length |

測試位置
check for fitting |
把磨平的14mm socket 推進26mm socket
push the 14 mm modified socket into 26mm socket
|

把多餘部份銼去 file
down extra parts |

成功
end result |
|
工具名稱: Tubular socket 通士
用途:在維修二級頭時,用來調較鏍釘工具,使用特別工具是因為部份二級頭的設計細小,一般工具不能使用。例如
Aqua Lung ABS, LPO。要把工具彎曲,必須先加熱,彎曲,再冷卻。
This tools is use for adjusting second stage
lock nut. Special modification is needed due to limited space in
some second stage model such as Aqua Lung ABS/LPO. To bend the
tools first heat it up to high temperature, bend the tools and
then cool it down. |
 
|
|
工具名稱:Target light Clamp 對焦灯夾
因為現時用的手電筒没有設安裝到相機壳,所以要自己動手做個夾,有咗佢方便好多。 |

|

|

|